Posts

Showing posts with the label silicon mold compound

Taking End Caps a Step Further

Image
Last Friday I shared by first sterling silver clay project - the bead end caps that I formed by hand.  This Friday I wanted to share my next experiment with bead end caps.  These are made with fine silver clay and I used a 2 part mold mixture from Cool Tools instead of hand forming them. The mold I made 2 parts to the mold and rolled my clay to 2 cards thick.  Placing the clay into the deep mold was more difficult than I anticipated.  The clay cracked and I had to repair it in several places.  It was a little scary taking the two parts of clay out of the molds.  After I wiggled the silicone mold, both pieces popped right out.  While they were drying on the cup warmer, I rolled the clay for the next end cap.  This time I rolled it 3 cards thick and it was easier to put into the mold halves.  It did not crack. Drying in the mold Drying on the cup warmer After both halves were dry, I attached them with clay paste and set them to dry again.  Sanding and smoothing and t

The Tortoise Continues (Making the Mold)

Image
A recap!   I carved a tortoise from red polymer clay in my previous post.    The turtle needed a little more detailing with a carving tool to make the design on the underside more visible.   Now it’s time for the next step – Making the Mold from the red tortoise model.        The two part mold compound in this case is Part A white and Part B purple.   When part A and B are mixed I have about 10-15 minutes of working time before the mixture sets.   A small amount of this mold making compound went with me to Tanzania where I made a mold of a beetle.   It amazed the guide and I gave him some to take home to his kids.   I always wondered what they did with it. Part A and B were mixed by pressing and folding them into each other.   Then I wrapped it around the red tortoise pressing so that the designs on the model would show in the mold.   To give a separation for the top and bottom of the turtle, I took an x-acto knife and cut the mold in half without removing the turtle.   The mold